Armada 50 WDG 2026 03 22

Which of the following is a specific application restriction for Armada 50 WDG?

• Do not apply by aerial application ✓
• Do not apply during daylight hours
• Do not apply to sports fields
• Do not apply if temperature is above 90 degrees

Answer: The restrictions section explicitly states 'Do not apply by aerial application.'

🔗 Source

Which of the following is a target pest for Armada 50 WDG?

• Dollar spot (Sclerotinia homoeocarpa) ✓
• Aphids
• Armyworms
• Grubs

Answer: Dollar spot is explicitly listed as a target pest in the application facts.

🔗 Source

When creating a tank mixture, what is the correct order for adding partners according to the label?

• Liquids first, then wettable granules
• Emulsifiable concentrates first, then wettable powders
• Wettable granules (like Armada 50 WDG), then liquid flowables, then emulsifiable concentrates ✓
• Any order is acceptable as long as the agitator is running

Answer: The label specifies the order: (1) water soluble packaging/wettable powders/granules, (2) liquid flowables/liquids, and (3) emulsifiable concentrates.

🔗 Source

To ensure the product reaches the crown and upper root zone for soil-borne diseases like summer patch, what should be done?

• Apply via aerial spray
• Irrigate immediately after application with sufficient water ✓
• Mix with an organosilicate-based product
• Wait 24 hours before watering

Answer: For soil-borne diseases, the notes state to use sufficient water to reach the crown/root zone or irrigate immediately after application.

🔗 Source

In which location should Armada 50 WDG be applied?

• Indoor residential carpets
• Greenhouse interior soil
• Outdoor turf sites ✓
• Indoor ornamental plants

Answer: All listed applications for the product specify 'Outdoor' as the location.

🔗 Source

According to the label, what is the recommended amount of water to use per 1,000 sq ft for thorough coverage?

• 0.5-1 gallon of water
• 1-2 gallons of water ✓
• 2-4 gallons of water
• 5 gallons of water

Answer: The label notes to apply the listed rate in 1-2 gallons of water per 1,000 sq ft to ensure thorough coverage.

🔗 Source

When mixing Armada 50 WDG alone, what is the correct procedure for adding water?

• Fill the tank completely with water before adding product
• Add the prescribed dose, then add all water at once
• Add 1/2 of the required water, add product with agitator running, then add remainder of water ✓
• Mix the product with a liquid flowable first, then add water

Answer: The mixing instructions state to add 1/2 of the required water, add the dose with the agitator running, and then add the remainder of the water.

🔗 Source

What is a required PPE precaution regarding treated areas?

• Wear a respirator for 48 hours after application
• Do not enter treated areas without protective clothing until sprays have dried ✓
• Avoid contact with soil for 7 days
• Use gloves only when mixing, not when entering areas

Answer: The PPE section states: 'Do not enter treated areas without protective clothing until sprays have dried.'

🔗 Source