CHIPCO 26019T FUNGICIDE

What is the required application rate for Brown Patch per 1,000 sq ft?

• 0.5 to 5 fl oz
• 3 to 5 fl oz ✓
• 4 to 7 fl oz
• 6 fl oz

Answer: The application table lists the rate for Brown Patch as 3 to 5 fl oz/1,000 sq ft.

🔗 Source

Which state has specific restrictions regarding the registration of this product for certain diseases?

• Texas
• Florida
• California ✓
• New York

Answer: The restrictions note that the product is not registered for use in California to control certain diseases.

🔗 Source

What is the maximum allowable application rate for CHIPCO 26019T FUNGICIDE in a single application?

• 3 fl oz per 1,000 sq ft
• 5 fl oz per 1,000 sq ft
• 6 fl oz per 1,000 sq ft ✓
• 7 fl oz per 1,000 sq ft

Answer: The restrictions state: 'Do not exceed 6 fl oz of product per 1,000 sq ft in a single application.'

🔗 Source

What is the restricted entry interval (REI) for this product?

• 12 hours
• 24 hours ✓
• 48 hours
• 7 days

Answer: The label specifies an REI of 24 hours.

🔗 Source

According to the label, where are the intended application sites for this product?

• Indoor residential carpets
• Greenhouse vegetable crops
• Outdoor turfgrass areas ✓
• Residential lawns

Answer: The label states that applications are intended for outdoor turfgrass areas and specifically warns not to apply to residential lawns.

🔗 Source

Which of the following diseases is CHIPCO 26019T FUNGICIDE specifically listed to control?

• Armyworms
• Pythium Blight ✓
• Aphids
• Japanese Beetles

Answer: The label explicitly lists Pythium Blight as one of the turfgrass diseases controlled by the product.

🔗 Source

Which set of Personal Protective Equipment (PPE) is required when using this product?

• Short-sleeved shirt and shorts
• Long-sleeved shirt, long pants, and chemical-resistant gloves ✓
• Respirator and heavy rubber apron
• Full body Tyvek suit and boots

Answer: The PPE section requires long-sleeved shirts, long pants, and chemical-resistant gloves.

🔗 Source

When treating Snow Mold, what is a critical timing/weather instruction regarding the spray mixture?

• Do not allow spray to stand for longer than 2 hours. ✓
• Apply only during high wind conditions.
• Wait 24 hours before applying water.
• Apply only when rain is expected immediately.

Answer: For Snow Mold, the notes state: 'Do not allow spray to stand for longer than 2 hours.'

🔗 Source