Enlite

Which of the following pest groups is Enlite designed to control in soybean crops?

• Annual grasses, broadleaf weeds, and certain perennials like morningglory ✓
• Only annual grasses and specific perennial weeds
• Insects and fungal pathogens affecting soybean leaves
• Only broadleaf weeds and morningglory

Answer: The label states Enlite controls annual grasses, broadleaf weeds, and certain perennial weeds such as morningglory and field bindweed.

🔗 Source

Which of the following is a specific geographic restriction for the use of Enlite?

• Do not apply in the state of New York ✓
• Do not apply in the state of California
• Do not apply in the state of Texas
• Do not apply in the state of Florida

Answer: The label explicitly states: 'Do not apply in the state of New York.'

🔗 Source

According to the label, where is Enlite intended to be applied?

• Outdoor soybean fields ✓
• Indoor greenhouse soybean crops
• Hydroponic soybean systems
• Only in the state of New York

Answer: The label identifies the location as outdoor soybean fields.

🔗 Source

When tank mixing Enlite with other herbicides, what action is required by the label?

• Perform a jar test for compatibility ✓
• Always mix with metsulfuron and chlorimuron-ethyl
• Dilute with water twice the standard amount
• Only mix with liquid formulations

Answer: The label notes that when tank mixing with certain herbicides, a jar test for compatibility must be performed.

🔗 Source

Which set of Personal Protective Equipment (PPE) is required for handlers of Enlite?

• Long-sleeved shirt, long pants, chemical-resistant gloves, and shoes plus socks ✓
• Short-sleeved shirt, long pants, and rubber boots
• Long-sleeved shirt, chemical goggles, and gloves
• Full body suit, respirator, and chemical-resistant gloves

Answer: The PPE requirements listed are long-sleeved shirt, long pants, chemical-resistant gloves, and shoes plus socks.

🔗 Source

What is the recommended application rate for Enlite per acre?

• 2.8 to 4.25 ounces per acre ✓
• 4.25 to 6.0 ounces per acre
• 1.5 to 3.0 ounces per acre
• 2.8 to 4.25 pounds per acre

Answer: The application rate specified in the label is 2.8 to 4.25 ounces per acre.

🔗 Source

Under which weather conditions should application of Enlite be avoided?

• High winds exceeding 10 mph and temperature inversions ✓
• Rainfall exceeding 0.5 inches
• Temperatures below 40 degrees Fahrenheit
• Humidity levels above 80%

Answer: The label instructs users to avoid application during high winds exceeding 10 mph and during temperature inversions.

🔗 Source

What is the Re-entry Interval (REI) for Enlite?

• 14 days ✓
• 24 hours
• 7 days
• 48 hours

Answer: The label specifies a re-entry interval (REI) of 14 days.

🔗 Source