Oust XP 2026 03 22

What is the primary target pest for Oust XP 2026 03 22 according to the label?

• Insects and mites
• Herbaceous weeds ✓
• Fungal pathogens
• Rodents

Answer: The label facts list 'herbaceous weeds' as the target pest for all listed applications.

🔗 Source

When performing Conifer Site Preparation in the Southeast for loblolly, longleaf, slash, or Virginia pine, what is the required application rate per acre?

• 1 to 2 ounces
• 2 to 4 ounces
• 2 to 4.25 ounces ✓
• 4 to 6 ounces

Answer: For Conifer Site Preparation (Southeast) for these specific pines, the rate is 2 to 4.25 ounces per acre.

🔗 Source

What is a critical restriction regarding the timing of applications in relation to tree growth?

• Applications should only be made during heavy rainfall
• Applications must be made after weeds have fully matured
• Applications at budbreak and later stages of active growth may severely injure or kill trees ✓
• Applications must be made during the peak of summer heat

Answer: The restrictions section states that applications at budbreak and later stages of active growth may severely injure or kill trees.

🔗 Source

When tank mixing Oust XP with other products, what rule must the user follow?

• Use the least restrictive limitations from both labels
• Use the most restrictive limitations from the labels of both products ✓
• Only follow the Oust XP label and ignore the other product
• Mix only if the weather is above 80 degrees

Answer: The restrictions state that when tank mixing, use the most restrictive limitations from the labels of both products.

🔗 Source

Where is the application of Oust XP 2026 03 22 intended to take place?

• Indoor only
• Outdoor only ✓
• Both Indoor and Outdoor
• Greenhouse environments only

Answer: All listed application sites in the label facts are categorized as 'Outdoor'.

🔗 Source

According to the mixing instructions for a broader spectrum of weeds in loblolly, slash, or longleaf plantings, what must be added to 2 - 4 ounces of Oust XP?

• 4 to 6 fluid ounces of imazapyr
• 1 1/2 - 3 pints of Velpar L VU or 8 - 16 ounces of Velpar DF VU ✓
• 2 to 4 ounces of sulfomethuron-methyl
• 1 to 2 ounces of imazapyr

Answer: The mixing notes specify adding 1 1/2 - 3 pints of Velpar L VU or 8 - 16 ounces of Velpar DF VU to the Oust XP amount.

🔗 Source

For ponderosa pine in California and other arid areas, when should the application be made?

• In the spring during active growth
• In the fall to transplant the following spring ✓
• During the summer transplanting season
• Immediately before budbreak

Answer: The timing/weather notes specify that for ponderosa pine in California and other arid areas, apply in the fall and transplant the following spring.

🔗 Source

In the West, if western red cedar is the primary species, what is the recommended application rate to avoid unacceptable injury?

• 2 to 3 ounces per acre ✓
• 2 to 4 ounces per acre
• 4 to 6 ounces per acre
• 1 to 2 ounces per acre

Answer: The label states that where western red cedar is a primary species, apply 2 to 3 ounces per acre to avoid unacceptable injury.

🔗 Source