Practice 8 Premise Pro 2026 03 22 exam questions with instant feedback and cited explanations.
To achieve a 0.10% finished strength for subterranean termites, how much product should be mixed with 100 gallons of water?
Answer: The mixing instructions state that 25 fl. oz. of product in 100 gallons of water results in a 0.10% finished strength.
When treating soil for subterranean termites, what dilution should be used for typical control situations?
Answer: The label states that a 0.05% dilution is generally used for typical control situations, within the 0.05% to 0.1% range.
When treating voids in hollow masonry units, how should the solution be applied?
Answer: The label notes for voids in hollow masonry units specify applying the solution so it reaches the footing by injecting into the lower areas of the wall.
What is the maximum allowable pressure for the treatment tool when using a low pressure spray for foundation perimeter treatment?
Answer: The label instructions for foundation perimeter trenching/rodding state to use a low pressure spray not to exceed 25 PSI.
When performing foundation perimeter trenching, what are the recommended dimensions for the trench?
Answer: The label specifies that when trenching, the trench along the outside foundation should be about 6 inches in width and 6 inches in depth.
Which of the following is a stated restriction for this product?
Answer: The restrictions section explicitly states: 'Do not formulate this product into other end-use products.'
According to the label, what is the primary target pest for the application methods listed?
Answer: The label facts specifically list subterranean termite as the target pest for all provided application scenarios.
If the fill under a slab consists of gravel or other coarse aggregate, what is the required application rate for subterranean termites in the soil?
Answer: For soil where fill under the slab is gravel or coarse aggregate, the rate is 1.5 gallons per 10 square feet.