Silencer

Which type of glove material is specifically required by the PPE section of the label?

• Barrier laminate or Viton ✓
• Latex or Nitrile
• Leather or Canvas
• Rubber or Neoprene

Answer: The PPE section requires chemical-resistant gloves specifically made of barrier laminate or Viton.

🔗 Source

Under which weather condition is application of Silencer prohibited?

• Wind velocity exceeding 15 mph ✓
• Temperatures below 40 degrees
• Humidity exceeding 80%
• Cloudy or overcast skies

Answer: The timing/weather instructions state: Do not apply if wind velocity exceeds 15 mph.

🔗 Source

When mixing Silencer, what is the correct procedure for filling the spray tank?

• Fill tank at least one-third full of clean water or diluent, add product, then add remaining water/diluent. ✓
• Fill tank completely with water, then add product to the top.
• Mix product with non-emulsifiable oils first, then add to the tank.
• Fill tank halfway with diluent, add product, then add the remaining half of the water.

Answer: The mixing notes state to fill the tank at least one-third full of clean water or diluent, add product, and then add the remaining water/diluent.

🔗 Source

What is the Re-entry Interval (REI) for Silencer?

• 24 hours ✓
• 12 hours
• 48 hours
• 72 hours

Answer: The label lists the REI as 24 hours.

🔗 Source

To prevent harm to non-target organisms, when should you avoid applying Silencer?

• When bees are actively visiting the treated area ✓
• When the sun is at its highest point
• When the soil is completely dry
• When the temperature is above 90 degrees

Answer: The label states to avoid application when bees are actively visiting the treated area because it is highly toxic to bees.

🔗 Source

According to the label, what is the application rate for Silencer when managing cutworms in orchard and vine crops?

• 50 gallons of finished spray per acre ✓
• 10 gallons of finished spray per acre
• 12.7 gallons of finished spray per acre
• 15 gallons of finished spray per acre

Answer: The label specifies a rate of 50 gallons of finished spray per acre for orchard and vine crops.

🔗 Source

Which of the following is a permitted method of application for Silencer?

• Sprinkler irrigation systems ✓
• Indoor fogging
• Direct water application
• Non-emulsifiable oil dilution

Answer: The label states the product can be applied through sprinkler irrigation systems.

🔗 Source

Which of these is a restriction regarding the use of diluents with Silencer?

• Do not use non-emulsifiable oils as diluents. ✓
• Only use distilled water as a diluent.
• Diluents must be at least 12.7% concentration.
• Do not use any diluent other than clean water.

Answer: The restrictions section explicitly states: Do not use non-emulsifiable oils as diluents.

🔗 Source