Transom 4 5 F Fungicide

When applying Transom 4 5 F to fine turf, what is the instruction regarding mowing?

• Mow immediately after application
• Mow at least 24 hours before application
• Apply after mowing or avoid mowing twelve hours after application ✓
• Mowing is prohibited for 48 hours after application

Answer: The timing/weather section states to apply after mowing or avoid mowing twelve hours after application.

🔗 Source

For Plant or Cutting Diseases, what is the required immersion time for plants or cuttings?

• 5-10 minutes
• 10-15 minutes ✓
• 15-30 minutes
• 48 hours

Answer: The label specifies to immerse plants or cuttings for 10-15 minutes for plant or cutting diseases.

🔗 Source

What is required to control Pythium or Phytophthora using this product?

• Increasing the application rate to 20 oz
• Applying the product as a drench instead of a spray
• Tank mixing with metalaxyl, mefenoxam, etridiazole, fosetyl-Al, or phosphorous acid salts/propamocarb ✓
• Soaking the plants for 30 minutes instead of 15

Answer: The label states tank mix combinations with specific chemicals are required for the control of Pythium and Phytophthora.

🔗 Source

Which of the following pathogens is NOT controlled by Transom 4 5 F Fungicide alone?

• Botrytis
• Pythium ✓
• Fusarium
• Rhizoctonia

Answer: The label explicitly states that Transom 4 5 F does not control Pythium or Phytophthora.

🔗 Source

According to the mixing instructions, how much product is used per 100 gallons of water for Plant or Cutting Diseases?

• 12-20 oz
• 16-20 oz ✓
• 8-12 oz
• 0.25-3.0 pints

Answer: The mixing section lists 16-20 oz per 100 gal for Plant or Cutting Diseases.

🔗 Source

To control Bulb, Corm, and Rhizome Rots, how long should cleaned bulbs be soaked in a warm solution (80-85°F)?

• 10-15 minutes
• 15-30 minutes ✓
• 30-45 minutes
• 48 hours

Answer: The label instructions for bulb rots state to soak cleaned bulbs for 15-30 minutes in a warm solution.

🔗 Source

When treating root pathogens in turf, how much water should be used to move the fungicide into the active root zone?

• 0.5 to 1.0 inch of water
• One to two tenths inch of water ✓
• 2 to 4 gallons per 1,000 square feet
• The area must be flooded completely

Answer: For root pathogens, the label instructs to lightly water the area with one to two tenths inch of water.

🔗 Source

When treating Stem, Crown, and Root Rots in propagation beds, what is the recommended application rate after transplanting?

• 8 oz
• 12-16 oz ✓
• 16-20 oz
• 2-4 gallons

Answer: For Stem, Crown, and Root Rots, the label specifies applying 8 oz after seeding/sticking or 12-16 oz after transplanting.

🔗 Source